Phone / Mcast; Table 7 - Mcast Parameters On Web - Fanvil X4 User Manual

Headset Mic Offset
G.729AB Payload Length
G.723.1 Bit Rate
G.722 Timestamps
DTMF Payload Type
Enable VAD
Enable MWI Tone
Auto Answer By Headset
7.18

PHONE / MCAST

This feature allows user to make some kind of broadcast call to people who are in multicast group.
User can configure a multicast DSS Key on the phone, which allows user to send a Real Time
Transport Protocol (RTP) stream to the pre-configured multicast address(es) without involving SIP
signaling. You can also configure the phone to receive an RTP stream from pre-configured multicast
listening address(es) without involving SIP signaling. You can specify up to 10 multicast listening
addresses.
Parameters
Normal Call Priority
Enable Page Priority
Name
Host:port
Fanvil Technology Co., Ltd
HQ Add: 4F, Block A, Building 1#, GaoXinQi Hi-Tech Park (Phase-II）, 67th District, Bao'An, Shenzhen, China 518101 P.R.
Tel: +86-755-2640-2199 Fax: +86-755-2640-2618
Beijing Tel:+86-10-5753-6809 Suzhou Tel: +86-512-6592-0605
This is to adjust the base volume of the headset
Mic.
Set G729 Payload Length.
5.3kb/s or 6.3kb/s is available
160/20ms or 320/20ms is available
Enter the DTMF payload type, the value must be
96~127.
Enable Voice Activity Detection. When enabled,
the device will suppress the audio transmission
with artificial comfort noise signal to save the
bandwidth.
The phone will play MWI tone when a new MWI
Comes
When this item is checked, the device will
auto-answer phone calls by headset if the
auto-answer or intercom is enabled.

Table 7 - MCAST Parameters on Web

Description
Define the priority of the active call, 1 is the
highest priority, 10 is the lowest.
The voice call in progress shall take precedence
over all incoming paging calls.
Listened multicast server name
Listened multicast server's multicast IP address
and port.
Email: sales@fanvil.com support@fanvil.com
<文档标题>