Valet Mode - Directed Electronics 554R Owner's Manual

valet mode

You can prevent your security system from passive arming by
using Valet mode. This is very useful when washing the vehicle
or having it serviced. In Valet mode, the security system will not
arm, even with the transceiver, but all convenience functions
(door locks, trunk release, remote starting, etc.) will continue to
work normally.
To enter or exit Valet mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
The status LED will light solidly if you are entering Valet mode,
and it will go out if you are exiting Valet mode.
The transceiver will not generate a page notification when
entering or exiting Valet mode using the Valet switch.
To enter or exit Valet mode using the transceiver:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solidly if you are entering Valet mode,
and it will go out if you are exiting Valet mode. The transceiver
will generate alarm/disarm page notifications since the observing
28
switch within 10 seconds.
DRW-35
© 2003 directed electronics, inc.