Valet Mode - Directed Electronics AutoCommand 20095 Owner's Manual

➜

Valet mode

You can prevent your security system from automatically arming
and triggering by using Valet Mode. This is very useful when
washing the vehicle or having it serviced. In Valet Mode, the
security system will not arm, even with the remote, but all
convenience functions (door locks, trunk release, etc.) will
continue to work normally.
To enter or exit Valet Mode:
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
To enter or exit Valet Mode using the remote:
Steps 2 through 3 must be quickly and smoothly completed.
1. Open any vehicle door.
2. Press
3. Press
4. Press
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
© 2005 directed electronics—all rights reser ved
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
button within 10 seconds.
.
.
again.
DRW-35
31