Setting The Clock; Temperature Check Mode - Directed Electronics 554R Owner's Manual

3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Start section for a complete list of shut-down inputs.)
note: This feature will not work if the brake pedal is
pressed or if any shut down input is active.

setting the clock

To set the clock press and hold
ceiver will chirp twice and the hour selection will start flashing.
Immediately press
reverse the hour selection. Once the correct hour is displayed
press again and the minute selection will start flashing.
Then press
reverse the minute selection. Once the correct time is displayed
simply stop pressing any buttons for 10 seconds and the trans-
ceiver will automatically exit the clock mode.

temperature check mode

This system will report the interior temperature of your vehicle
with the press of two buttons. To activate the temperature
display press
melody and the interior temperature will appear on the LCD
screen for five seconds.
note: If the ignition is on, the temperature check clock-
mode will not work.
32
for five seconds, the trans-
to advance the hour selection or
to advance the minute selection or
and simultaneously. You will hear a
to
to
© 2003 directed electronics, inc.