Disarming Without A Transceiver; (Emergency Override); Silent Mode - Directed Electronics 554R Owner's Manual

disarming without a transceiver (emergency override)
If your transceiver is lost or damaged, you can manually disarm
your vehicle security system. To disarm the system without a
transceiver, you must have the vehicle's ignition key and know
where the Valet
®
installer at the time of installation for both the location and the
preset response (1-5 presses) of the Valet
To disarm the security system,
turn the ignition to the ON posi-
tion. Press the Valet button the
preset number of times (one to five
times) within five seconds. The
factory preset is one. After five
seconds, the system will disarm. If
the system does not disarm, you
may have waited too long; turn the
ignition off and on and try again.
Location of Valet Button_________________________________
Number of Presses_____________________________________
important! The Valet
respond to 1-5 presses for the disarm function. You must
check with the installer to verify the programming for
your individual unit.

silent mode

To temporarily turn off the arm or disarm chirps, use Silent
Mode™. Simply press
26
switch is located. Be sure to check with your
switch can be programmed to
®
for less than one second before
switch.
®
DRW-35
© 2003 directed electronics, inc.