Vehicle Protection - Directed Electronics 554R Owner's Manual

3. The status LED will blink at twice its normal rate indicating
the system has begun the 30 second countdown.
4. After 20 seconds the siren will chirp once (unless
programmed off ) as an audible indication that the system is
about to arm.
5. At 30 seconds the system will fully arm itself. At this time the
lights will flash and the doors will lock (if programmed for
passive locking).
The LED will flash and transceiver's arm icon (29) will appear and
remain displayed on the LCD. However, the transceiver will not
chirp or vibrate confirmation.
note: The system will not passively arm if a protected entry
or sensor is active; unless forced passive arming has been
programmed on. Refer to the Programming Options section
for information about forced passive arming.

vehicle protection

Following are descriptions of the many ways this system protects
the vehicle. Included are descriptions of the types of alarm pages
and how to interpret them.
D D o o o o r r L L o o c c k k s s ( ( i i f f a a v v a a i i l l a a b b l l e e ) ) - The system will automatically lock
the vehicle doors when armed.
F F a a i i l l - - s s a a f f e e S S t t a a r r t t e e r r K K i i l l l l - The Fail-Safe Starter Kill will prevent
the vehicles starter motor from cranking when armed.
S S t t a a t t u u s s L L E E D D - - The status LED blinks approximately once per
second as a visual deterrent to potential vehicle theft.
© 2003 directed electronics, inc. 19