Directed Electronics 554R Owner's Manual page 33

4. In gasoline vehicles, the engine will start four seconds after
the parking lights flash. In diesel vehicles, the engine will
start when the WAIT-TO-START indicator on the vehicle's
dash goes out.
5. Once the vehicle has started, it will run for the pre-program-
med period of time (either 12, 24, or 60 minutes - see
Programming Options section of this guide) or until a shut-
down input is triggered. When using the Directed Bitwriter,
the run time can be programmed from 1-60 minutes.
important! It is unsafe to operate a vehicle's motor in a
garage or other closed off area. Breathing the exhaust
from the vehicle is hazardous to your health. Never acti-
vate the remote start in an enclosed space.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn
2. Press the brake pedal.
note: If the brake pedal is pressed before the key is in the
ON position, the engine will shut down.
To shut down the remote start and turn off the engine:
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut
down the engine if the system receives any of the following shut-
down inputs:
The brake pedal is pressed.
30
it to the ON (not the START)
position.
© 2003 directed electronics, inc.