Directed Electronics 554R Owner's Manual page 50

circuitry for the starter interrupt, however installation may
require additional labor.
A physical connection to the system. An input can be
Input:
provided by a sensor, pinswitch or by existing systems in the
vehicle, such as ignition or courtesy lights.
A red light mounted at a discretionary location inside the
LED:
vehicle. It is used to indicate the status of your system and as a
visual deterrent.
A protected entry is a door, hood, trunk, sliding
Protected Entry:
window, camper door or any other opening into the vehicle that
can be connected to the alarm with a switch.
This system has a dual zone shock sensor. This
Shock Sensor:
sensor is mounted in the vehicle and designed to pick up impacts
to the vehicle or glass. Lighter impacts will generate a Warn Away
response while harder impacts will generate a full-trigger response.
A hand-held device that operates the various
Remote Control:
functions of your system and communicates system status.
This is what happens when the alarm "goes
Triggered Sequence:
off " or "trips." The triggered response of your system consists of
the siren sounding and parking lights flashing for the
programmed duration.
A small push button mounted at a discretionary
Valet Switch:
location inside the vehicle. It is used to override the starter inter-
rupt when a transceiver is lost or damaged, or to enter or exit
© 2003 directed electronics, inc. 47