Table of Contents
Advertisement
Disarming and rearming the system does not reset NPC. The only way to reset NPC is for the 60 minutes to pass,
without a trigger, or for the ignition to be turned on. This allows the system to be repeatedly triggered, disarmed
and rearmed, and still allow NPC to bypass a faulty zone.
When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been
bypassed. (See Diagnostics section of this guide.)
valet mode
To enter or exit valet mode with the valet/program switch:
1.
2.
To enter or exit Valet mode with the transmitter:
To enter or exit Valet Mode with a transmitter:
1. Open any door.
2. Press
on the transmitter.
3. Press
.
4. Press
again. You have now entered or exited Valet Mode (verify by checking your status LED).
rear defogger control
The rear defogger output can be remotely turned on/off any time using the remote control. The default setting
is ON.
To turn the rear defogger output OFF:
1. Press & release the
2. The parking lights will flash 2-times.
56
Turn the ignition key on and then off.
At anytime during the next 10 seconds, press and release the Valet switch. Now the Status
LED will light constantly if you have entered Valet® Mode, and go out if you have exited
Valet Mode.
and
and
DRAFT
buttons of the remote control.
© 2005 Directed Electronics—all rights reserved
Advertisement
Table of Contents
Troubleshooting
