針高度之調 整
1.轉 動 皮 帶 輪 使 針 上 升 至 最 高 點 時 , 針 尖
至 針 板 面 之 距 離 為 。(圖29)
2.調 整 :
( 1)打 開 上 蓋 。
( 2)放 鬆 螺 絲 , 移 動 針 棒 至 所 需 高 度
鎖 緊 螺 絲 回 。
( 3)放 回 上 蓋 , 並 且 密 合 鎖 緊 。
押具調整
1.押 具 位 置 調 整 :(圖30)
( 1)放 鬆 押 具 彈 簧 壓 力
( 2)移 動 押 具 , 使 其 押 具 槽 與 針 板 槽 一
致 , 使 押 具 底 平 壓 於 針 板 上 , 鎖 緊 螺
絲 。
( 3)放 鬆 螺 絲 , 左 右 移 動 , 使
疊 吻 合 , 且
能 上 下 活 動 輕 順 , 鎖 緊
螺 絲 。
及 押 具 螺 絲 。
與
-28-
ADJUST THE NEEDLE HEIGHT
1.The
is the distance from the needle tip to
the surface of the needle plate when the
needle is rised to the highest point after
turning the pulley.(Fig.29)
2.Adjustments:
(1)Open and remove the upper cover
(2)Loosen the screw
needle bar to the desired height. Then,
tighten the screw
(3)Put the upper cover
ADJUST THE PRESSER FOOT
1.Adjust the presser toot position:(Fig.30)
(1)Release the pressure spring
presser foot and the screw
presser foot.
(2)Move the presser foot
groove of the presser foot can align with
the groove of the needle plate. Also, the
bottom of the presser toot can stand on
the needle plate flatly, and then tighten
the screw .
(3)Loosen the screw
and right so that
can move upward and downward
smoothly. Then, tighten the screw
.
, and move the
.
back, and seal it.
圖29/Fig. 29
of the
of the
so that the
, and move
left
can match
and
.