Siruba 700Q Instruction Book page 44

控 制 箱調整
1.電機轉速操作設定(圖46)
本公司出廠設定為5000rpm，調速旋鈕
逆時針旋轉至底為最低轉速200rpm，順
時針轉到最底為5000rpm。如需修正電
機最大轉速時，需先行打開外殼並針對
撥碼開關做設定，再調整調速旋鈕，以
達電機轉速調整之動作。例如當撥碼開
關設定4000rmp時，調速旋鈕逆時針旋
轉至底為最低轉速200rpm，順時針轉到
最底為4000rpm。
(1)撥碼開關設定(SW1)
CONTROL BOX SETTING
1.Motor speed settings( Fig.46)
The factory default setting is at 5000rpm,
and the minimum speed is at 200rpm when
speed control knob is turning
counterclockwise to the end, and at
5000rpm when turning clockwise to the
bottom. To amend the maximum motor
speed, you need to open the case first to
set the DIP switch settings, and then adjust
the speed control knob. For example, when
the DIP switch settings is 4000rmp, the
minimum speed is at 200 rpm when turning
the speed control knob counterclockwise to
the end, and at 4000rpm when turning
clockwise to the bottom.
(1)DIP switch settings
-38-
圖45/Fig. 45
圖46/Fig. 46