Install The Belt Cover; Install And Adjust The Synchronizer - Siruba C007K Manual

B. Belt Stopper Adjustment:
a. Factory default Belt stopper is mount at pulley scale about 100 mm's position (Fig. A ), if pulley size change, follow the Fig. B.
b. Adjustment tips: Move stopper pointer aligned with any position at pulley diameter scale that matches the pulley diameter size,
Cover top view

(5). Install the Belt Cover:

a).Install the belt cover bracket at motor
front cover.(screw hole face motor)
Secure belt cover bas
b
c
).After install base, mount with the motor pulley and secure it.
Belt cover base
(6). Install and Adjust the Synchronizer (sensor):
a). Synchronizer installation：Mounting the Synchronizer onto the flange of machine pulley and fasten the
b). Synchronizer adjustment ： Before adjustment, unscrew the synchronizer's cover screw, and remove the
Caution :
Turn OFF the power, before
making the adjustment.
if didn't know the pulley diameter size, please push the stopper until to touch the pulley then return back
5-10mm position.
Belt Stopper vs Pulley diameter
( As show at right )
e
Secure belt cover bracket
a
Screw hole
Mount with motor pulley
c
rotor by setting screws.
cover.
Pulley size use 100 mm or above
Securing point (Fig. A )
100
110
120
130
A
b).Then secure base to the belt cover bracket, let the
opening face machine pulley.
Motor
d).Finally put the belt cover and secure screw A, B
Set screw
Bearing cover
Photo Plate (A)
Photo Plate (B)
6
Pulley size use 90 mm or under
Securing point (Fig. B )
50
60
70
80
B
90
e
Secure belt cover bas Secure belt cover bracket
Secure belt cover
d
A
. .
B
.