Adjust The Needle Height; Adjust The Presser Foot - Siruba 700KST Instruction Book

針高度之調整
1. 轉動皮帶輪使針上昇至最高點時，針尖至針
板面之距離為 (a)。( 圖 22)
2. 調整 :
(1) 打開上蓋①。
(2) 放鬆螺絲②，移動針棒至所需高度鎖緊螺絲
②。
(3) 回覆上蓋須密合鎖緊。
押具調整
1. 押具位置調整
(1) 放鬆押具壓力①及押具螺絲②。
(2) 移動押具③使其押具槽與針板之針槽一致
押具底平押於針板上，鎖緊螺絲②。
(3) 放鬆螺絲④左右移動⑤，使⑥與⑦吻合，且
⑥能上下活動輕順，鎖緊螺絲④。
(4) 調整適當壓力，螺絲①順時針方向旋轉，壓
力加大，反之減弱。( 圖 23)

ADJUST THE NEEDLE HEIGHT

1.Turn the pulley to raise the needle to the top
point. The distance between the tip of the
needle to the needle plate is (a). (Fig.22)
2.Adjustment:
(1)Open the upper cover ①.
(2)Loosen the screw ②, and move the needle
bar to the required height. Then, tighten the
screw ②.
(3)Put the upper cover back and lock it closely.
Standard
High stroke

ADJUST THE PRESSER FOOT

1.Adjust the position of the presser
(1)Loosen the pressure of the preser ① and
the screw of the presser ②.
(2)Move the presser ③ to align the groove
of the needle plate and the groove of the
presser. The bottom side of the presser
touches the needle plate flatly. Then, tighten
the screw ②.
(3)Loosen the screw ④ and move ⑤ right-left
to engage ⑥ with ⑦ and ⑥ could move
smoothly. Then, tighten the screw ④.
(4)Adjust the appropriate pressure. Turn the
screw ① clockwise to enlarge the pressure.
The opposite way lowers down the
pressure. (Fig.23)
Introduction
圖 22 / Fig. 22
P17