Planning The Installation - DCS RGTC-305 Installation Manual

PLANNING THE INSTALLATION

IMPORTANT INSTALLATION INFORMATION
The RGTC-305 is tested in accordance with ANSI Z21.1 Standard for Household Cooking Gas Appliances.
The range must be installed in conjunction with a suitable overhead vent hood. (See ventilation requirements,
page 11). Due to the professional high heat capacity of this unit, particular attention should be paid to the hood
and duct work installation to ensure it meets local building codes. To eliminate risk of burns or fire by reaching
over heated surface units, cabinet storage located above the surface units should be avoided.
All range models with less than a 12" clearance between combustible material and the back edge of the range,
require the installation of one of the two offered Wall Mount Backguards – see page 15.
Wall Mount Full
Backguard
(Model No.
BGS-3030)
1-5/16"
Wall Mount
Low Backguard
(Model No.
BGS-1230)
1-5/16"
Fig. 01
Check local building codes for the proper method of range installation. Local codes vary. Installation, electrical
connections, and grounding must comply with all applicable codes. In the absence of local codes, the range /
cooktop should be installed in accordance with the National Fuel Gas Code ANSI Z223.1 and National Electrical
Code ANSI / NFPA 70-1990.
Be sure that the unit being installed is set up for the kind of gas being used. The gas range is shipped from the
factory set and adjusted for Natural Gas or LP (propane), depending on the specific model ordered. Verify
that the range is compatible with the gas type at the installation site before proceeding
further. Return range to dealer if the unit is not set for the gas supplied at the site.
28-1/8"
10-1/8"
7