Unpacking And Handling - DCS RGTC-305 Installation Manual

UNPACKING AND HANDLING

To remove door:
1. Open the door all the way open (Fig. 06).
2. Unlock the door hinges by rotating the lock forward (Fig. 07).
3. Once both hinges are unlocked, gently begin to close the door until approximately halfway closed. Grabbing
the sides of the door and gently lifting up and slightly forward, the door will unlatch from the hinge. DO NOT
lift door by the handle - will cause damage!
4. Continue to lift and pull the door away from the range.
Fig. 06
OVEN HINGE ASSEMBLY
To re-install door:
1. Position the door in approximately halfway open position.
2. Simply place the hinge tongue into the hinge slots (See
Fig. 08).
3. Push the door into the slots until you feel them fall into the latches.
4. Open the door completely and rotate the locks into the closed position (Fig. 09).
5. Close the oven door.
HINGE
HINGE
T T ONGUE ONGUE
HINGE SL O T
HINGE SL O T
Fig. 08
HINGE ASSEMBLY
10
Fig. 07
HINGE RETAINER CLIP IN UNLOCKED POSITION
Fig. 09
HINGE RETAINER CLIP IN LOCKED POSITION