Table of Contents
Advertisement
Using H.323 Protocol
Configuration Main Page
TFTP Server: This is the IP address of the host where the TFTP server
is running. It must be in dot-separated form. An illegal IP address won't
be allowed for this field.
Firmware Filename (up to 6 characters): This is the filename of the
firmware that you want to download from the TFTP server. It may be a
maximum of 6 characters long. It should start with a letter and should
consist of digits, letters, and an underscore.
Upload Filename (up to 6 characters): This is the filename to upload
the configuration parameters from the phone to the TFTP server. It may
be a maximum of 6 characters. It should start with a letter and should
consist of digits, letters, and an underscore.
Download Filename (up to 6 characters): This is the filename to
download the configuration parameters from the TFTP server to the
phone. It may be a maximum of 6 characters long. It should start with a
letter and should consist of digits, letters, and an underscore.
Adaptive Jitter: If this is enabled then the Jitter Buffer will be adaptive,
otherwise it will use a fixed buffer of a size specified in Maximum Buffer
Size.
Maximum Buffer Size: If the adaptive jitter is disabled, the phone will
use this static value for Jitter Buffer size. This should be in the range of
0-300 in ms.
Log Server: This flag is turned on in case the user wants to log all debug
messages for viewing.
Log Server Address: This is the IP address of the machine where all
the log messages should be sent. It must be in dot-separated form. An
illegal IP address won't be allowed for this field.
Log Server Port: This is the port number on the log server to which the
log messages are sent. It should be a valid port number in the range of 0-
65335. The user should make sure that it is not one of the reserved port
numbers.
67
Advertisement
Table of Contents
