Table of Contents
Advertisement
Using Media Gateway Control Protocol (MGCP)
General Configuration
Firmware Filename (up to 6 characters): This is the filename of the
firmware that you want to download from the TFTP server. It may be 6
characters long at maximum. It should start with a letter and should consist
of digits, letters, and an underscore.
Upload Filename (up to 6 characters): This is the filename to upload
the configuration parameters from the phone to the TFTP server. It may
be 6 characters long at maximum. It should start with a letter and should
consist of digits, letters, and an underscore.
Download Filename (up to 6 characters): This is the filename to
download the configuration parameters from the TFTP server to the
phone. It may be 6 characters long at maximum. It should start with a
letter and should consist of digits, letters, and an underscore.
Adaptive Jitter: If this is enabled, then the Jitter Buffer will be adaptive.
Otherwise it will use a fixed buffer of a size specified in Maximum Buffer
Size.
Maximum Buffer Size: If the adaptive jitter is disabled, the phone will
use this static value for the Jitter Buffer size. This should be in the range
of 0-300 ms.
Log Server: This allows the user to log all debug messages for viewing.
Log Server Address: This has the IP address of the machine where all
the log messages should be sent. It must be in dot-separated form. An
illegal IP address won't be allowed for this field.
Log Server Port: This is the port number on the log server to which the
log messages are to be sent. It should be a valid port number in the
range of 0-65335. The user should make sure that it is not one of the
reserved port numbers.
Microphone Gain: This will show the microphone gain in the range of
-14 to 14 (unit of dB).
16
Advertisement
Table of Contents
