Table of Contents
Advertisement
Using Session Initiated Protocol (SIP)
Configuration Main Page
Obtain IP address using: If the static option is selected, then a user-
configured IP address, Net Mask, Default gateway, and DNS server ad-
dress will be used for the phone. If DHCP is selected, then these values
will be obtained using DHCP. If PPPoE is selected, and using the PPP
username and password for authentication, PPPoE obtains an IP ad-
dress for the phone. Default selection is Static-enabled.
PPP user name: This is the user name used for PPP authentication with
the PPP server while obtaining an IP address via PPPoE.
PPP password: This is the password used for PPP authentication with
the PPP server while obtaining an IP address via PPPoE.
Idle Timeout: This is the time interval, in seconds, of session inactivity
after which the PPP session should be terminated. If this is set to 0, then
the session will never be terminated. This field is currently grayed so that
it can't be modified. This will allow the PPP session to be on permanently
unless the server closes the connection. This field can be made active
later to enable a configuration of timeout value.
IP Address: This is the IP address of the phone in dot-separated IP
address form. An illegal IP address won't be allowed for this field.
Net Mask: This is the Net Mask of the network to which the IP phone is
connected. It must be in dot-separated form. An illegal IP address mask
won't be allowed for this field.
Default Gateway: This is the default gateway for the IP phone. An illegal
IP address won't be allowed for this field.
DNS server Address: This is the IP address of the DNS server, which
will respond to the DNS queries from the IP phone. It must be in dot-
separated form. An illegal IP address won't be allowed for this field.
TFTP Server: This has the IP address of the host where TFTP server is
running. It must be in dot-separated form. An illegal IP address won't be
allowed for this field.
39
Advertisement
Table of Contents
