Parameters Table - Eliwell ICPlus 915 Manual

Electronic controller with 2 intervention points

Hide thumbs

Table Of Contents

Table of Contents

PAR. DESCRIPTION

Temperature control setpoint SP1. The SEtpoint is visible from the

SP1

machine status menu and not from the programming menu.

Temperature control setpoint SP2. The SEtpoint is visible from the

SP2

machine status menu and not from the programming menu.

CONTROLLER 1 (folder 'rE1')

This sets the controller 1 operating mode.

HC1

H (0) = Hot; C (1) = Cold.

OS1 Temperature value to be added to SP1 if reduced set enabled

Operating band 1.

db1

(See 'ON/OFF regulation diagram')

OUT1 activation differential.

dF1

The utility stops on reaching the SP1 value (as indicated by control probe) and

restarts at a temperature value equal to T=SP1+dF1 relative to HC1.

HS1 Maximum value assignable to setpoint SP1.

LS1 Minimum value assignable to setpoint SP1.

Maximum temperature alarm on OUT1.

HA1

(See 'Max/Min temperature alarms')