Eliwell ICPlus 915 Manual page 21

PAR. DESCRIPTION
Controller 2 switch-off time in the event of faulty probe.
OF2 if OF2=1 and On2=0, the controller remains off;
if OF2=1 and On2>0, the controller operates in Duty Cycle mode.
SOFT START CONTROLLER (folder 'SFt')
Value (in °C) of each subsequent increase (dynamic) of the setpoint.
dSi
0 = disabled.
dSt Time between two subsequent increases (dynamic) of the Setpoint.
Unt Unit of measurement (parameter dSt). 0 = hours; 1 = minutes; 2 = seconds.
Establishes which outputs the function must be enabled on:
Sen
0 = disabled; 1 = OUT 1; 2 = OUT 2; 3 = OUT 1 & 2
Function reactivation threshold. Establishes the threshold beyond which the
Sdi
SOFT START function is automatically reactivated.
CYCLIC CONTROLLER (folder 'cLc')
Con Output ON time.
CoF Output OFF time.
ALARMs (folder 'AL')
Parameters 'HA1/HA2' and 'LA1/LA2' , intended as the absolute temperature
Att value or differential in relation to the setpoint.
AbS (0) = absolute value; rEL (1) = relative value.
AFd Alarm differential.
PAO Alarm override time after device is switched on following a power failure.
MODEL RANGE VALUE M.U. LEVEL
ALL 0...250
NTC/PTC 0.0...25.0
PT100-Tc
0.0...25.0
V/I 0...25
ALL 0...250
ALL 0/1/2
ALL 0/1/2/3
NTC/PTC 1.0...50.0
PT100-Tc 1.0...50.0
V/I 1...50
ALL 0...250
ALL 0...250
ALL AbS/rEL
NTC/PTC
1.0...50.0
PT100-Tc 1.0...50.0
V/I 1...50
ALL 0...10
1 min Inst
0.0 °C/°F
0.0 °C/°F Inst
0 num
0 min Inst
0 num Inst
0 num Inst
2,0 °C/°F
2.0 °C/°F Inst
2 num
0 min Inst
0 min Inst
AbS flag Inst
2.0 °C/°F
2.0 °C/°F Inst
2 num
0 hours Inst