Eliwell ICPlus 915 Manual page 17

The Copy Card is connected to the serial port (TTL) and allows rapid programming of the instrument parameters.
Access Installer parameters by entering 'PA2' , scroll through the folders using
through the parameters using
• Upload (UL): Select UL and press
procedure is a success, 'y' , will appear on the display, otherwise 'n' will appear.
• Format (Fr): This command is used to format the copy card (recommended when using the card for the first time).
Important: the Fr parameter deletes all data present. This operation cannot be cancelled.
• Download:
Connect the Copy Card when the instrument is switched off. At power-on, data is downloaded from the copy card to the
instrument automatically. At the end of the lamp test, the display will show 'dLy' if the operation was successful and 'dLn' if not.
NOTE: After downloading, the instrument works with the settings of the new map just downloaded.
D.I. FROM KEY OR FROM MENU
H13
STATE ENABLED
NO open YES
NO closed YES
NC open YES
NC closed YES
NOP open YES
NOP closed
NCP open YES
NCP closed N/A
USING THE COPY CARD
and , then select the function using
. This function uploads the programming parameters from the instrument to the card. If the
H13 PARAMETER CONFIGURATION
DISABLED
YES
YES
YES
YES
YES
NO N/A
YES
NO
and until folder FPr appears. Select it using
(eg. UL).
FUNCTION
COMMENTS
STATE
ON enabled / disabled with each mode
OFF enabled / disabled with each mode
OFF enabled / disabled with each mode
ON enabled / disabled with each mode
ON enabled only from D.I. / disabled with each mode
OFF Enabled only when D.I. is reopened
OFF enabled with each mode / disabled only from D.I.
ON enabled with each mode / disabled only from D.I.
, scroll