Accessing And Using The Menus - Eliwell ICPlus 915 Manual

The resources are organized into 2 menus which are accessed as follows:
• 'Machine Status' menu: press and release the
• 'Programming' menu: hold down the
Either do not press any keys for 15 seconds (timeout) or press the
screen.
Password 'PA1': used to access User parameters. The password is not enabled by default (PS1=0).
To enable it (PS1≠0): press and hold
PS1, press
to display the value, modify it using
order to access the User parameters.
Password 'PA2': used to access Installer parameters. The password is enabled by default (PS2=15).
To modify it (PS2≠15): press and hold
label PA2, press , set the value to '15' using
diS and press
to enter. Scroll through the parameters using
modify it using and
The visibility of 'PA2' is as follows:
1) PA1 and PA2 ≠ 0: Press and hold
access the User parameters (PA1) or the Installer parameters (PA2).
2) Otherwise: The password PA2 is amongst the level1 parameters. If enabled, it will be required when accessing the Installer
parameters; to enter it, proceed as instructed for password PA1.
If the value entered is incorrect, the label PA1/PA2 will be displayed again and the procedure will need to be repeated.

ACCESSING AND USING THE MENUs

key for 5 seconds.
for longer than 5 seconds, scroll through the parameters using
for longer than 5 seconds, scroll through the parameters using
and
, then save it by pressing
for longer than 5 seconds to display PA1 and PA2. It will then be possible to decide whether to
key.
key once, to confirm the last value displayed and return to the previous
PASSWORD
and , then save it by pressing
, then confirm using
until you see the label PS2, press
and
or .
and
or . If enabled, it will be required in
and
. Scroll through the folders until you find the label
until you see the label
until you see the
to display the value,