Arris Touchstone TG1662G User Manual page 21

2. Hold the battery pack so that the guides on the battery align with the slots on the
Telephony Gateway and slide the battery into the bay.
1 - Battery Slots
2 - Battery Guides
3 - Battery Pull Strap
Note: Batteries will not insert completely into the Telephony Gateway if not oriented
correctly. The battery should slide into the bay without significant force. Line up the slots
in the battery bay with the guides on the battery and apply even pressure on both ends of
the battery.
3. Push the battery pack into the bay until it latches into place. If you are taking the battery
out of the Telephony Gateway, use the battery pull strap to dislodge the battery.
Note: The Telephony Gateway will not begin operating until you apply AC power.
4. Replace the door. To do so, place the tabs of the battery door into the slot inside the
Telephony Gateway battery compartment. Rotate the door toward the front of the
Telephony Gateway until the latch snaps back into place.
Release 16 STANDARD 1.1 August 2016
© 2013-2016 ARRIS Enterprises LLC. All Rights Reserved.
Chapter 4: Battery Installation and Removal
Touchstone TG1662G Telephony Gateway User Guide
21