Connecting The Telephony Gateway - Arris Touchstone TG1662G User Manual

Connecting the Telephony Gateway

WARNING
Risk of injury or equipment damage
Connecting the Telephony Gateway to the home's existing telephone wiring should only be
performed by a professional installer. Physical connections to the previous telephone provider
must be removed and the wiring must be checked; there must not be any voltage. Cancelation
of telephone service is not adequate. Failure to do so may result in loss of service and/or
permanent damage to the Telephony Gateway.
1. Connect one end of the coax cable to the cable outlet or splitter, and the other end to the
Telephony Gateway's Cable connector (6). Tighten the connections by hand, then tighten
an additional 1/8 turn with a wrench.
Note: For best performance, use high-quality coax cable and minimize or eliminate
splitters between the cable jack and the Telephony Gateway. If you are using MoCA for
your home network, MoCA filters must be installed on any legacy client devices. Your
service provider will install these filters for you.
2. Insert the plug from the power cord into the Power connector on the back of the
Telephony Gateway (7) and insert the power cord into a convenient AC outlet.
Release 16 STANDARD 1.1 August 2016
© 2013-2016 ARRIS Enterprises LLC. All Rights Reserved.
Chapter 5: Installing and Connecting your Telephony Gateway
Touchstone TG1662G Telephony Gateway User Guide
30