BT 2000 User Manual page 64

DRC is only available if the setting of user function
Off, there is no effect on ringer in Telephone/Fax auto
answering mode.
When you answer an incoming call on a telephone
connected to the same line as your fax or via an
attached handset, you can tell your fax machine to
switch to fax mode to receive an incoming fax by
entering a 2-digit code. Use the keypad of a handset
or an external phone to enter the code number you
have set into your machine. Original setting = OFF.
The setting controls how your machine normally sends
messages – either via the document feeder (FEEDER)
or by scanning documents into the memory and then
sending. Original settings = MEMORY.
This function depends on the setting for
. If Instant Dialling is set to On, all documents
are scanned into the memory automatically. To use the
MEM/FEEDER settings, you should switch Instant
Dialling to Off.
Your machine can be set to use substantially less
power 3 minutes after the last button press. When in
Power Save Mode, the display shows
normal operation when the telephone rings, when
the handset is lifted or when you load a document,
press Start. Original setting = OFF.
61
is available. Also, when set to
. To resume
It is recommended that Power Save Mode is not
used because your PC cannot switch the machine
back to full operation.
If you switch Power Save Mode on, once the
machine has 'gone to sleep', you will not be able to
print from a PC without first 'waking up' your
eF@x 2000 by pressing the
The error correction mode helps your machine
improve communication quality where telephone
line conditions are poor. When using ECM the
sending machine will re-send a document as
necessary if the receiving machine cannot verify
the transmission. Using ECM increased the
transmission time because data is checked as it is
sent. Original setting = ON.
This allows an engineer to dial and service your
machine via the telephone line. Original setting = OFF.
When your eF@x 2000 is set to receive in PC
Receive Mode and your MFP software is set to
receive fax messages, all incoming calls are
transferred directly to your PC. How ever, if you are
having problems with your PC, you can switch this
function On so that your eF@x 2000 will receive and
print faxes direct. Original setting = ON.
When switched On, your machine automatically
receives and stores incoming faxes in the memory
when the toner level is low. When switched Off,
messages are printed even if the toner is low or
empty. Original setting = ON.
button.