BT 2000 User Manual page 76

Do not expose the image drum unit to light for more
than 5 minutes. Always hold the image drum unit by
the ends.
Carefully pull out any paper you see inside the
machine.
Replace the image drum unit. Ensure that the tabs
on both sides of the drum slot into the machine
as shown. Press down firmly on both ends of the
drum until it clicks into place.
Close the top cover.
Push the control panel back until it clicks into
place.
Pull the paper out of the paper tray. If any of the
sheets are damaged, remove them.
Reload the paper.
When the cartridge is almost empty, the display
shows
starts to get lighter. You should replace the
cartridge immediately.
Replacement toner cartridges and image drum units
can be obtained by telephoning
It is important that you do not use any toner other
than that specifically intended for use in the eF@x
2000. Using the wrong toner may damage your
machine and invalidate your guarantee.
73
and the print quality
.
Be careful when handling the toner cartridge. See
Safety information, page 8.
If you open the top cover, you will see a label that reads
. This area is extremely hot and must
not be touched.
Open the top cover.
Pull the control panel up and forward.
Do not expose the image drum unit to light for more
than 5 minutes. Always hold the image drum unit by
the ends.