BT 2000 User Manual page 65

If the memory when storing pages, the display
shows
If you press
Scanning stops and the display shows
and remove the remaining pages from the document
feeder. Any pages of the document scanned into the
memory are deleted.
If you press
All the pages scanned into the memory will be sent.
Then the display changes to
You can send the remaining pages as a separate
transmission. Original setting = ON.
When set to On, and you do not press the
button within one minute the messages
, your machine will send the pages
automatically.
When set to Off, and you do not press the
within one minute the messages
, your scanned pages are deleted from the
memory.
When switched On, your machine will give a
continuous tone while receiving a fax. Pressing
once turns off the tone. When switched Off,
your machine gives a short beep after each fax
received. Original setting = OFF.
With this feature switched On, and when sending a
fax to a single destination, your machine
automatically scans the document into the memory
and dials the number. Original setting = ON.
before changing to
. Now press
.
button
Lets you select whether or not you want prevent
unauthorised people from using your machines.
Select On to activate and then set your restricted
access codes. See page 64. Original setting = OFF.
Switch to On to print your incoming faxes at a
slightly reduced width. Original setting = ON.
This allows you to make changes to the settings of
a button, without changing the normal
communications settings used by your machine.
62