BT 2000 User Manual page 21

For Windows 95, Windows 98 or Windows
NT4.0:
Click on Start, then highlight Settings and
click on Control Panel.
On the Control Panel screen, double click
Add/Remove Programs.
Click on Install and follow the on-screen
prompts to run SETUP.EXE from the CD.
(You can double click on the file to run it.)
For Windows 3.1 (or 3.11):
In Program Manager, choose RUN from the
FILE menu.
In the Command Line, type D:\SETUP.EXE
(where D = your CD drive).
When following the on-screen prompts for
installation:
You are asked which device to install, select
select eF@ax 2000.
When prompted by the INSTALL programme,
enter your name, company, voice and fax
number and PC sender ID number (this is
the number that will be printed at the top of
faxes sent from the PC, it would normally
be your fax number, including your area
code). The fax number and sender ID can
contain up to 20 digits and must be
completed before you can proceed.
When asked to select the installation type,
it is recommended that you choose Typical.
(Custom install is for advanced users and
allows you to deselect certain features. You
will also be asked which COM ports to use
for faxing and printing. Please note that these
do not correspond to actual connectors on
your PC but are locations used inside the
computer and, in most cases, you shouldn't
change the ports that are selected
automatically.)
Click on NEXT and follow on-screen prompts
until the software is installed
When installation is complete, the program
will restart your computer so that you can
use JetSuite Pro.
Register the software by visiting www.caere.com or
by calling free on
Alternatively, you can register by:
Completing and faxing the registration form
included in the eF@x 2000 packaging.
Load the completed form face down in the
document tray.
Enter the fax number provided on the registration
form (along with a prefix, if necessary, to get an
outside line).
Press the button on your eF@x 2000.
When the fax has been sent successfully, the
display shows
.
.
18