TP-Link T3700G-28TQ User Manual page 397

Jetstream 28-port gigabit stackable l3 managed switch

Hide thumbs Also See for T3700G-28TQ:

Table of Contents

2） Power off and restart the switch. When you are prompted that "Press CTRL-B to enter the

bootutil" in the hyper terminal, please press CTRL-B key to enter into bootutil menu shown

as Figure 19-6.

As the prompt is displayed for a short time, you are suggested not to release the CTRL-B key

until you enter into bootutil menu after powering on the switch.

3） After entering into bootutil menu, please firstly configure the IP parameters of the switch.

Enter 5 and specify the IP address, IP mask and gateway in turn.

Figure 19-6 bootutil Menu