TP-Link T3700G-28TQ User Manual page 264

Choose the menu Multicast Routing→PIM SM→BSR to load the following page.
The following entries are displayed on this screen:
PIM SM Candidate BSR Config

Configure the candidate BSR of current device.
Interface:
Hash Mask Length:
Priority:
PIM SM Elected BSR Information

BSR Address:
Priority:
Hash Mask Length:
Next BSR message
time:
Expire:
Figure 11-22 BSR
Select the interface on this switch from which the BSR
address is derived to make it a candidate. This interface must
be enabled with PIM SM.
specify the mask length that is to be ANDed with the group
address before the hash function is called. All groups with the
same seed hash correspond to the same RP The valid value
range from 0 to 32 and the default value is 30.
Specify the priority of the BSR. The BSR with the larger priority
is preferred. If the priority values are the same, the device with
the highest IP address is selected as the BSR. The valid value
range from 0 to 255 and the default value is 64
Displays the elected BSR address.
Displays the priority of the elected BSR.
Displays the hash mask length of the elected BSR.
Displays the time of next BSR message sending if this is the
elected BSR.
Displays the expiry time of the elected BSR.
252