Hardware Hookup - Crestron QM-FTDC Operation And Installation Manual

Fliptop data center

Hide thumbs Also See for QM-FTDC:

Table of Contents

Crestron QM-FTDC

Operations & Installation Guide – DOC. 6312A

3. Install the four #10 screws in the mounting brackets (two screws per

bracket). Refer to the following diagram.

4. Slide the mounting brackets over the #6-32 screws and tighten the

#6-32 screws.

5. Turn the four #10 screws equally until they contact the underside of the

mounting surface.

NOTE: Do not over-tighten the #10 screws as this may damage the surface

and/or the unit.

Mounting Bracket Installation

NOTE: Be careful not to press the buttons while closing the FlipTop, even

though the buttons are disabled when the FlipTop begins to close and all pressed

buttons are released.

Hardware Hookup

Refer to the following hookup diagram and, aside from attaching power last,

complete the connections in any order.

NOTE: To prevent overheating, do not operate this product in an area that

exceeds the environmental temperature range listed in the specifications table.

Consideration must be given if installed in a closed or multi-unit rack assembly,

inside a closed desk, or in a closed podium since the operating ambient

temperature of these environments may be greater than the room ambient.

Contact with thermal insulating materials should be avoided on all sides of the

unit.

FlipTop Data Center

FlipTop Data Center: QM-FTDC • 21

Table of Contents