Table of Contents
Advertisement
FlipTop Data Center
1
2
125V – 50/60Hz 10A
12 • FlipTop Data Center: QM-FTDC
Teleconferencing Ports
One 8-pin RJ-45 and two 6-pin RJ-11 communication passthrough ports
(labeled 1, 2 and 3) are provided for use with telephone and teleconferencing
devices. Bottom labels should match top labels.
3
Use the label set (included) to change the designations of these ports.
AC Power
Connect the six-foot (183 cm) grounded AC line cord to supply AC power to the
outlet on the topside of the QM-FTDC.
The international version (QMI-FTDC) is equipped with a standard IEC-320
electrical appliance coupler. The IEC (International Electrotechnical
Commission) is the international standards and conformity assessment body for
all fields of electrotechnology.
Indicators
PWR (Power)
This LED illuminates when 24 volts DC is supplied to the QM-FTDC from
Cresnet.
NET
This LED illuminates when communication between the control system and the
QM-FTDC is established (the unit is polled on the network). Illumination
indicates that the SIMPL Windows program currently loaded has a network
device defined at the same Net ID as the QM-FTDC.
Bargraphs
Two sets of eight-segment programmable red LEDs are provided that can be
programmed to display audio level settings. The LEDs display is proportional to
the input and can be set from zero to 100%. Refer to "Buttons" on page 38 for
programming details.
NOTE: Indicators are not included with NB models.
SETUP LED and Pushbutton
The QM-FTDC is Touch-Settable ID-ready. A SETUP pushbutton is located on
the bottom side of the QM-FTDC. The SETUP pushbutton and its associated
LED are used for setting a units network ID during the initial configuration of a
Cresnet system or when the device is being added/replaced.
Crestron QM-FTDC
Operations & Installation Guide - DOC. 6312A
Advertisement
Table of Contents
