Hyundai H-1 2003 Owner's Manual page 88

page of 173

/ 173
Contents
Table of Contents
Bookmarks

Table of Contents

H290B01P-GAT

1. 1. 1. 1. 1. POWER ON-OFF Control Knob

POWER ON-OFF Control Knob

The radio unit may be operated when the igni-

tion key is in the "ACC" or "ON" position. Press

the button to switch the power on. The display

shows the radio frequency in the radio mode or

the tape direction indicator in the tape mode, or

CD track either the CD mode or CD AUTO

CHANGER mode. To switch the power off,

press the button again.

VOLUME Control

Rotate the knob clockwise to increase the vol-

ume and turn the knob counterclockwise to

reduce the volume.

2. 2. 2. 2. 2. BASS/BALANCE Control Knob

BASS/BALANCE Control Knob

BASS Control Knob

Press to pop the knob out. To increase the

bass, rotate the knob clockwise, while to de-

crease the bass, rotate the knob counterclock-

wise.

BALANCE Control knob

Further pull the popped-up knob. Rotate the

knob clockwise to emphasize right speaker

sound. (Left speaker sound will be attenuated)

When the control knob is turned counterclock-

wise, left speaker sound will be emphasized

(Right speaker sound will be attenuated).

INSTRUMENTS & CONTROLS

3. 3. 3. 3. 3. TREBLE/FAD Knob

TREBLE/FAD Knob

TREBLE Control Knob

Press to pop the knob out and turn to the left or

right for the desired treble tone.

FAD (Fader Control) Knob (Minibus

only)

Further pull the popped-up knob. Turn the con-

trol knob counterclockwise to emphasize front

speaker sound. (Rear speaker sound will be

attenuated) When the control knob is turned

clockwise, rear speaker sound will be empha-

sized. (Front speaker sound will be attenuated)

4. 4. 4. 4. 4. TUNE (Manual) Select Button

TUNE (Manual) Select Button

Press the ( ) side or ( ) side to increase or to

decrease the frequency. With the button held

down for 0.5 sec. or more, the stop signal

(broadcasting radio wave) is ignored and chan-

nel selection continues.

SEEK Operation (Automatic Channel

Selection)

Press the TUNE select button for 1 sec or

more, and releasing will automatically tune the

next available station with beep sound.

When the ( ) side is pressed longer than 1

second and releasing will automatically tune

the next higher frequency and when the (

side is pressed longer than 1 second and re-

leasing will automatically tune the next lower

frequency.

5. 5. 5. 5. 5. PRESET STATION Select Buttons

PRESET STATION Select Buttons

Six (6) stations for AM, FM and FM2 respec-

tively can be preset in the electronic memory

circuit.

HOW TO PRESET STATIONS

Six AM and twelve FM stations may be pro-

grammed into the memory of the radio. Then,

by simply pressing the band select button and/

or one of the six station select buttons, you may

recall any of these stations instantly. To pro-

gram the stations, follow these steps:

o Press band selector to set the band for AM,

FM and FM2.

o Select the desired station to be stored by

seek or manual tuning.

o Determine the preset station select button

you wish to use to access that station.

o Press the station select button for more than

two seconds. A select button indicator will

show in the display indicating which select

button you have depressed. The frequency

display will flash after it has been stored into

the memory with beep sound. You should

then release the button, and proceed to

program the next desired station. A total of

18 stations can be programmed by selecting

one AM and two FM station per button.

o When completed, any preset station may be

)

recalled by selecting AM, FM or FM2 band

and the appropriate station button.

2-49

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

Hyundai H-1 2003 Owner's Manual page 88

Hide quick links:

Related Manuals for Hyundai H-1 2003

Related Products for Hyundai H-1 2003

Table of Contents