Hyundai H-1 2003 Owner's Manual page 50

C140A01P-GAT
MULTI-FUNCTION LIGHT SWITCH MULTI-FUNCTION LIGHT SWITCH MULTI-FUNCTION LIGHT SWITCH
MULTI-FUNCTION LIGHT SWITCH MULTI-FUNCTION LIGHT SWITCH
3
2
1
Rotate the switch to turn on the lights.
1. Lights off
2. Position, tail, licence-plate, and instrument
panel lamps on
3. Headlights on
To operate the headlights, turn the barrel on
the end of the multifunction switch.
Parking light auto cut (If installed) Parking light auto cut (If installed) Parking light auto cut (If installed) Parking light auto cut (If installed) Parking light auto cut (If installed)
If you do not turn the parking lights "OFF" after
driving, the parking light will automatically shut
"OFF" when the driver's door is opened.
To turn them "ON" again you must simply turn
the ignition key to the "ON" position.
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
C150A01P-GAT
TURN SIGNAL SWITCH TURN SIGNAL SWITCH TURN SIGNAL SWITCH
TURN SIGNAL SWITCH TURN SIGNAL SWITCH
HSR2114
Pulling down on the lever causes the turn
signals on the left side of the car to blink.
Pushing upward on the lever causes the turn
signals on the right side of the car to blink. As
the turn is completed, the lever will automati-
cally return to the center position and turn off
the turn signals at the same time. If either turn
signal indicator light blinks more rapidly than
usual, goes on but does not blink, or does not
go on at all, there is a malfunction in the
system. Check for a burned-out fuse or bulb or
see your Hyundai dealer.
C160A01P-GAT
HIGH-BEAM SWITCH HIGH-BEAM SWITCH HIGH-BEAM SWITCH
HIGH-BEAM SWITCH HIGH-BEAM SWITCH
HSR2113
To turn on the headlight high beams, push the
lever forward (away from you). The High Beam
Indicator Light will come on at the same time.
For low beams, pull the lever back toward you.
C170A01P-GAT
PASSING SWITCH PASSING SWITCH PASSING SWITCH PASSING SWITCH PASSING SWITCH
HSR2112
HSR2115
2-11