Hyundai H-1 2003 Owner's Manual page 117

The jack handle is stored as shown in the
figure.
To assemble, follow the steps below.
1. Loosen the holding nut and pull out the
handle.
2. Insert the opposite end of the handle, and
then tighten the holding nut.
4-2
IN CASE OF EMERGENCY IN CASE OF EMERGENCY IN CASE OF EMERGENCY
IN CASE OF EMERGENCY IN CASE OF EMERGENCY
E040A02P-GAT
JACKING UP THE VEHICLE JACKING UP THE VEHICLE JACKING UP THE VEHICLE
JACKING UP THE VEHICLE JACKING UP THE VEHICLE
2WD
The method for jacking up the vehicle should
GS40050A
be remembered in order to change a tire in the
event of a puncture and in order to install tire
chains.
4WD
GS40060A
After stopping the engine and applying the
parking brake on a flat level surface, also use
chocks to hold the wheels.
RR
Position the jack only at the specified points
E040A01P-1
indicated in the illustration, and the use of the
jack at other points could damage the vehicle
body.
Jack handle
Using the jack handle, turn the relief valve
E040A02P-GAG
clockwise until it reaches a stop.
E040A03P-GAG
Relief valve
GS40080A