Hyundai H-1 2003 Owner's Manual page 121

E060A02P-GAT
IF A TIRE IS FLATENED IF A TIRE IS FLATENED IF A TIRE IS FLATENED
IF A TIRE IS FLATENED IF A TIRE IS FLATENED
If a tire must be changed due to a flat, do so
only after first following every precaution for
safety parking the vehicle in a place where it is
not a traffic hazard or dangerous to you and
your vehicle's occupants, on a flat surface, and
in such a way that you will not be injured by any
part of the vehicle while changing the tire.
4-6
IN CASE OF EMERGENCY IN CASE OF EMERGENCY IN CASE OF EMERGENCY
IN CASE OF EMERGENCY IN CASE OF EMERGENCY
1. Comply with local regulations concerning
the protection of broken-down vehicles by
switching on the hazard warning flashers,
setting up a warning triangle flashing signal
lamp, etc., at an adequate distance from the
vehicle.
Others in the vehicle should get out of the
vehicle and wait in a safe place.
GT40140A
2. Position the vehicle on a flat, hard surface
and apply the parking brake.
To prevent the vehicle from rolling when it is
raised on the jack, chock the wheel diago-
nally opposite to that being changed.
3. Prepare the spare wheel, jack and wheel
nut wrench.
C260A01P-GAG
Flat tire
4. The spare tire should be placed, for safety,
GS40160A
5. Loosen the wheel nuts with the wheel nut
under the vehicle and near the jack for
convenient access when ready to be
mounted.
2WD 4WD
E060A05P-GAG
wrench as shown in the drawing. Do not
remove the wheel nuts yet.
GT40170A