Hyundai H-1 2003 Owner's Manual page 67

C700A01P-GAT
Operation Tips Operation Tips Operation Tips
Operation Tips Operation Tips
o If the interior of the vehicle is hot when you
first get in, open the windows for a few
minutes to expel the hot air.
o When you are using the air conditioning
system, keep all windows closed to keep
hot air out.
o When you must drive slowly, as in heavy
traffic, shift to a lower gear. This increases
engine speed, which in turn increases the
speed of the air conditioning compressor.
o When driving up long grades, turn occa-
sionally the air conditioner off to avoid the
possibility of the engine overheating.
o During winter months or in periods when the
air conditioner is not used regularly, turn on
the air conditioner switch occasionally for a
few minutes. This will help circulate the
lubricants and keep your system in peak
operating condition.
C710A01P-GAT
REAR HEATER (If installed) REAR HEATER (If installed) REAR HEATER (If installed) REAR HEATER (If installed) REAR HEATER (If installed)
The rear heater can be operated with the igni-
tion switch at the "ON" position by depressing
the main switch in the instrument panel.
2-28
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
C720A01P-GAT
Main switch for the rear heater Main switch for the rear heater Main switch for the rear heater
Main switch for the rear heater Main switch for the rear heater
The main switch for the rear heater is installed
in the instrument panel.
The main switch should be used to switch the
power of the rear heater ON and OFF.
The power is switched ON when the button is
pressed, and the lamp within the switch is
illuminated. Illumination will stop and the power
will be switched OFF when the button is pressed
once again.
C730A01P-GAT
CONTROL PANEL CONTROL PANEL CONTROL PANEL
CONTROL PANEL CONTROL PANEL
2
REAR HEATER & A/CON
(ROTARY TYPE)
C720A01P-GAG
REAR HEATER & A/CON
(LEVER TYPE)
1. 1. 1. 1. 1. Mode selector lever Mode selector lever Mode selector lever Mode selector lever
Mode selector lever
Air flow can be switched in three modes.
Three symbols are used to represent Floor
Heat, Bi-level and Vent Air position.
1 3
C730A01P-1
1
3
2
C730A02P-1