Hyundai H-1 2003 Owner's Manual page 77

K240B01TB-GAT
1. POWER ON/OFF, VOLUME 1. POWER ON/OFF, VOLUME 1. POWER ON/OFF, VOLUME
1. POWER ON/OFF, VOLUME 1. POWER ON/OFF, VOLUME
Press this button to turn on/off the audio when
the ignition switch is at ACC or ON position.
Once the system is on, you can increase or
decrease the volume by rotating the knob clock-
wise or counter-clockwise. Press this button
again to
turn it off.
2. TUNE 2. TUNE 2. TUNE
2. TUNE 2. TUNE
Press the button not more than 0.5 second
then frequency is increased.
Likewise press the button not more than 0.5
second to decrease the frequency.
With the button held down for 0.5 sec or more,
the beep sound will be heard and frequency will
increase or decrease rapidly. if you release the
button after the beep sound, seek function is in
operation.
o o o o o SEEK SEEK SEEK SEEK SEEK
Press the button for over 0.5 second and
release the button after beep sound, then it will
tune to the next receivable higher frequency
station. Likewise, press the
0.5 second and release the button after the
beep sound, then it will tune to the next receiv-
able lower frequency station. if the selected
station is in the preset memory, memorized
channel will be on the display too.
2-38
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
3. PRESET 3. PRESET
3. PRESET 3. PRESET 3. PRESET
Press any of these buttons not more than 2
seconds to listen to the station in memory.
Press the preset button for 2 seconds or more,
then the current station will be stored into the
memory of the preset button with the sound.
4. SCAN Button 4. SCAN Button
4. SCAN Button 4. SCAN Button 4. SCAN Button
When this button is pressed, the frequency will
be increased to be tuned to the next receivable
station one after another, receiving each station
for 5 seconds. if the desirable station is tuned,
press this button (scan) again to cancel scan
function.
5. BASS/BAL- pull 5. BASS/BAL- pull 5. BASS/BAL- pull
5. BASS/BAL- pull 5. BASS/BAL- pull
Press to pop the knob out, To increase the
bass, rotate the knob clockwise, while to de-
crease the Bass, rotate the knob counterclock-
wise. Further pull the popped-ed knob for the
balance control. Rotate the knob clockwise to
emphasize right speaker sound. (Left speaker
sound will be attenuated) When the control
knob is turned counter-clockwise, left speaker
sound will be emphasized. (Right speaker will
button for over
be attenuated)
6. TREB/pull-FAD 6. TREB/pull-FAD
6. TREB/pull-FAD 6. TREB/pull-FAD 6. TREB/pull-FAD
Press the pop the knob out and turn clockwise
to increase the treble or counterclockwise to
decrease the treble. Further pull the popped-up
knob for the Fader control. Turn the control
knob counter clockwise to emphasize front
speaker sound.
(Rear speaker sound will be attenuated) When
the control knob is turned clockwise, rear
speaker sound will be emphasized. (Front
speaker sound will be attenuated)
7. FM/AM Button 7. FM/AM Button
7. FM/AM Button 7. FM/AM Button 7. FM/AM Button
FM/AM band button, which is used to change
the band repeatedly in the following manner .
FM1→FM2→AM→FM1
(FM1→ FM2 → M → L → FM1 : Europe)
8. LCD 8. LCD 8. LCD
8. LCD 8. LCD
LCD shows the following information; band of
FM1/FM2/AM frequency, preset channel num-
ber, ST in case of FM Stereo.