Hyundai H-1 2003 Owner's Manual page 73

K210B01TB-GAT
1. POWER ON/OFF, VOLUME 1. POWER ON/OFF, VOLUME 1. POWER ON/OFF, VOLUME
1. POWER ON/OFF, VOLUME 1. POWER ON/OFF, VOLUME
Rotate the Power switch clockwise to turn on
the audio when the ignition switch is at ACC or
ON position. Once the system is on, you can
increase or decrease the volume by rotating the
knob clockwise or counter-clockwise.
o o o o o BALANCE BALANCE BALANCE BALANCE
BALANCE
Further pull the volume button and rotate clock-
wise to emphasize right sound speaker.
Or rotate counter-clockwise to emphasize left
sound speaker.
o o o o o SCAN Button SCAN Button SCAN Button SCAN Button SCAN Button
When this button is pressed, the frequency will
be increased to be tuned to the next receivable
station one after another, receiving each station
for 5 seconds. if the desirable station is tuned,
press this button (scan) again to cancel scan
function.
2. BASS/TREBLE-pull 2. BASS/TREBLE-pull
2. BASS/TREBLE-pull 2. BASS/TREBLE-pull 2. BASS/TREBLE-pull
Press this button to pop up. Rotate the knob
clockwise to increase the Bass and rotate to
counter-clockwise to decrease the Bass.
Further pull the button and rotate clockwise to
increase the Treble.
Or rotate counter-clockwise to decrease the
Treble. After adjustment press the button.
2-34
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
INSTRUMENTS & CONTROLS INSTRUMENTS & CONTROLS
3. PRESET ( 1 ~ 6 ) 3. PRESET ( 1 ~ 6 )
3. PRESET ( 1 ~ 6 ) 3. PRESET ( 1 ~ 6 ) 3. PRESET ( 1 ~ 6 )
Press any of these buttons not more than 2
seconds to listen to the station in memory.
Press the preset button for 2 seconds or more,
then the current station will be stored into the
memory of the preset button.
4. LCD 4. LCD
4. LCD 4. LCD 4. LCD
LCD shows the following information; band of
FM1/FM2/AM/(L)/(M) frequency, preset chan-
nel number, ST in case of FM Stereo.
5. TUNE 5. TUNE 5. TUNE 5. TUNE 5. TUNE
Press the button not more than 1 second
then frequency is increased. Likewise press
the button not more than 1 second to de-
crease the frequency.
o o o o o SEEK SEEK SEEK SEEK SEEK
Press the button for over 1 second, then it
will tune to the next receivable higher frequency
station. Likewise, press the
1 second then it will tune to the next receivable
lower frequency station.If the selected station is
in the preset memory, memorized channel will
be on the display too.
6. FM/AM Button 6. FM/AM Button
6. FM/AM Button 6. FM/AM Button 6. FM/AM Button
FM/AM band button, which is used to change
the band repeatedly in following manner.
FM1→ FM2 → AM → FM1
(FM1→ FM2 → M → L → FM1 : Europe)
7. Fader (If installed) 7. Fader (If installed) 7. Fader (If installed) 7. Fader (If installed) 7. Fader (If installed)
This button is located top side of the volume
switch. Rotate clockwise to attenuate front
speaker sound. Rotate counter-clockwise to
attenuate rear speaker sound.
button for over