Hyundai H-1 2003 Owner's Manual page 104

D070A01P-GAT
DRIVING WITH ELECTRONIC DUAL- DRIVING WITH ELECTRONIC DUAL- DRIVING WITH ELECTRONIC DUAL-
DRIVING WITH ELECTRONIC DUAL- DRIVING WITH ELECTRONIC DUAL-
RANGE AUTOMATIC TRANSMISSION RANGE AUTOMATIC TRANSMISSION RANGE AUTOMATIC TRANSMISSION RANGE AUTOMATIC TRANSMISSION RANGE AUTOMATIC TRANSMISSION
(If installed) (If installed) (If installed)
(If installed) (If installed)
The electronically controlled dual-range (Pow-
er/Normal) 4 speed automatic transmission is
available for you Hyundai.
According to the road conditions, set the switch
at the "NORMAL", "POWER" or "HOLD" mode
for normal driving, for greater power driving or
for shift stage hold driving.
Each time you press the switch, the "NOR-
MAL", "POWER" and "HOLD" modes will switch
alternately. The "POWER" and "HOLD" indica-
tor in the instrument panel comes on or off.
Normally, drive your vehicle in the "NORMAL"
mode where the switch is not pressed. (The
"PWR" and "HOLD" indicators go out.)
STARTING & OPERATING STARTING & OPERATING STARTING & OPERATING
STARTING & OPERATING STARTING & OPERATING
D070B01P-GAT
"Normal" Mode "Normal" Mode "Normal" Mode
"Normal" Mode "Normal" Mode
The "N" (Normal) mode offers quiet and smooth
auto-shifting with outstanding fuel economy.
The "N" (Normal) mode is recommended for
normal driving. Set the driving pattern selector
switch to the "N" (Normal) position. Push the
selector lever to the "D" range and depress the
accelerator pedal slowly. If you need rapid
acceleration, fully depress the accelerator ped-
al.
D070C01P-GAT
"Power" Mode "Power" Mode "Power" Mode
"Power" Mode "Power" Mode
D070A01P-1
In the "Power" mode, you can obtain full poten-
tial of the engine for maximum acceleration and
driveability. The "Power" mode is recommend-
ed for higher speeds than the "Normal" mode,
driving in mountainous areas and for strong
acceleration. Set the driving pattern selector
switch to the "Power" position.
D070D01P-GAT
"Hold" mode "Hold" mode "Hold" mode
"Hold" mode "Hold" mode
Select the "HOLD" mode when starting your
vehicle on a road surface slippery from snow or
the like, and the vehicle will start smoothly in
second gear.
When you need quick acceleration or engine
braking power on a downhill grade, or when you
are going to go up a long hill, press the "Hold"
switch once again to cancel the "Hold" function.
When "Hold" button is depressed, "Hold" indi-
cator light in the instrument cluster will illumi-
nate and automatic shifting will be performed in
D070C01P-1
the range from 2nd gear to 3rd gear only, as
shown in the table.
Position
1
2
3
4
D070D01P-1
Shifting gear
2
2
3
3
3-7