Hyundai H-1 2003 Owner's Manual page 133

G290B02P-AAT
Adjustment After Headlight Assembly Adjustment After Headlight Assembly Adjustment After Headlight Assembly Adjustment After Headlight Assembly Adjustment After Headlight Assembly
Replacement Replacement
Replacement Replacement Replacement
30mm(1.18in.)
Horizontal line
15mm (0.59in.)
Cut-off line
L
H
If the vehicle has had front body repair and the
headlight assembly has been replaced, the head-
light aiming should be checked using the aiming
screen as shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustra-
tion.
2. Dotted lines in the illustration show center of
headlights.
4-18
IN CASE OF EMERGENCY IN CASE OF EMERGENCY IN CASE OF EMERGENCY
IN CASE OF EMERGENCY IN CASE OF EMERGENCY
"H";
Horizontal center line of headlights from
ground.
MINIBUS
Vertical
line
W
VAN(2WD) : 855 mm (33.66 in.)
TRUCK
"P"
H
"W";
Ground line
Distance between each headlight center.
MINIBUS/VAN(2WD/4WD)
:1300mm (51.18 in.)
G290B01Y
Truck (Long wheel base/Extra long
wheel base) : 1272 mm (50.08 in.)
"L";
Distance between the headlights and the
wall that the lights are tested against
: 3,000 mm (118.11 in.).
2WD:849 mm (33.43 in.)
4WD:972 mm (38.27 in.)
Long Wheel base
:847 mm (33.35 in.)
Extra long Wheel base
:845 mm (33.27 in.)
E130D01P-GAT
Front combination lamps Front combination lamps Front combination lamps
Front combination lamps Front combination lamps
Minbus/Van
Truck
Remove the bezel attaching screw from the
front combination lamp.
Then turn the bulb socket counterclockwise to
remove it.
To remove the bulb of the side turn-signal
lamps, turn the bulb counterclockwise while
pressing it inward.
E130A01P-1
E130C01P-1