VersaLogic Ocelot Reference Manual page 15

Distributor of VersaLogic Corporation: Excellent Integrated System Limited
Datasheet of VL-CBR-2012 - 20" 24-BIT LVDS CABLE
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
LVDS
VL-CBR- 2012
or
VL-CBR-2011
1. Install Memory

Insert the DDR2 DRAM module into the SO-DIMM socket J14 and latch it into
place.
2. Attach Cables and Peripherals

Plug the LVDS cable VL-CBR-2012 (or Hirose alternative VL-CBR-2010) or
VL-CBR-2011 into socket J6. Attach the cable to the LVDS display. (Note: You
can attach an analog monitor to connector J6 using the VL-CBR-2014 adapter
card.)

Plug the breakout board VL-CBR-5012 into socket J7.

Plug a USB keyboard and USB mouse into socket J1 of the breakout board.
(Note: In DOS, input is through a keyboard only. Due to a limitation of the
BIOS, mouse function is not supported in DOS.)

Plug the hard drive data cable VL-CBR-4406 into socket J5. Attach a hard drive
and CD-ROM drive to the connectors on the cable. If the hard drive is 3.5", use
the 2 mm to 0.1" adapter VL-CBR-4405 to attach the IDE cable.
 Attach an ATX power cable to any 3.5" drive (hard drive or CD-ROM drive).

Set the hard drive jumper for master device operation and the CD-ROM drive
jumper for slave device operation.
VL-EPMs-21 Reference Manual
VL-EPMs-21
OCELOT
J6
J11
VL-CBR- 1008
ATX
Power Supply
Power
to
Drives
Figure 2. Typical Start-up Configuration
Configuration and Setup
USB Keyboard
and USB Mouse
J5 J7
VL-CBR- 4406
Hard
Drive
CD-ROM
Drive
J1
J4
VL-CBR- 5012
OS Installation
CD-ROM
8