Pc Configuration; Installation Tasks; Install The Visualdsp++ Software - Analog Devices ADSP-21992 EZ-KIT LITE Manual

The EZ-KIT Lite evaluation board contains ESD (electrostatic
discharge) sensitive devices.
accumulate on the human body and equipment and can
discharge without detection. Permanent damage may occur on
devices subjected to high-energy discharges.
precautions are recommended to avoid performance degradation
or loss of functionality. Store used EZ-KIT Lite boards in the
protective shipping package.

2.3 PC Configuration

For correct operation of the VisualDSP++ software and the EZ-KIT Lite evaluation system, your
computer must have the minimal configuration shown in Table 2-1.
Windows 98, Windows 2000, Windows XP
Intel (or comparable) 166MHz processor
VGA Monitor and color video card
2-button mouse
50MB free on hard drive
32 MB RAM
Full-speed USB port
CD-ROM Drive
! Note: This EZ-KIT Lite does not run under Windows 95 or Windows NT.

2.4 Installation Tasks

The following tasks are provided for the safe and effective use of the ADSP-21992 EZ-KIT Lite.
Follow these instructions in the order presented to ensure correct operation of your software and
hardware. Perform the following tasks to install the ADSP-21992 evaluation system.
1. Install VisualDSP++ software and EZ-KIT Lite debug software
2. Install VisualDSP++ license
3. Set up EZ-KIT Lite hardware
4. Install EZ-KIT Lite USB driver
5. Verify the USB driver installation
6. Start VisualDSP++

2.4.1 Install the VisualDSP++ Software

This EZ-KIT Lite comes with the latest version of VisualDSP++ for the ADSP-219x and ADSP-
2199x DSP families.
1. Insert the VisualDSP++ CD-ROM into the CD-ROM drive.
2. If Auto Run is enabled on your PC, the home screen of the VisualDSP++ install wizard
will appear. Otherwise, choose Run from the Start menu, and enter D:\Setup.exe in the
ADSP-21992 EZ-KIT Lite Evaluation System Manual
Electrostatic charges readily
Proper ESD
Table 2-1: Minimum PC Configuration
2-7