Rack Mounting - Extron electronics MTP 1500RL 15HD RS Series User Manual

Installation, cont'd

Rack mounting

On the standard rack shelf, the MTP 1500RL receiver can be
mounted in one of four locations to the rear of the rack or in one
of four locations to the front of the rack.
Front false
faceplate
uses 2
screws.
Figure 2 — Mounting the MTP on a standard shelf
1.
2.
C
3.
MTP 1500RL 15HD RS Series • Installation
5
1U Universal Rack Shelf
Use 2 mounting holes on
opposite corners.
Remove the feet from the bottom of the MTP, if they are
installed.
Mount the MTP using two 4-40 x 3/16" screws in opposite
(diagonal) corners to secure the MTP to the shelf.
DO NOT stack units on top of one another as this
may cause the units to overheat.
Install false faceplate(s) or other unit(s) to the rack shelf.
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
NOTE:
Using screws longer
than 3/16" will damage the
unit and void the warranty.