Front Panel Controls And Indicators - Extron electronics MTP 1500RL 15HD RS Series User Manual

Front Panel Controls and Indicators

Front panel features on the MTP 1500RL 15HD RS series
receivers are shown below.
1
1
Figure 7 — MTP receiver series front panels
a
Power LED — Indicates power is applied to the MTP.
b
Select button (SEQ models only) — This recessed button selects
the red, green, or blue video signal to adjust and resets all three
video signals to a skew delay of zero nanoseconds.
Use a small screwdriver to press and release this button to cycle
and select the red, green, or blue video signal to adjust. The
selected signal is indicated by the Red, Green, and Blue LEDs
c
( ).
N
c
Red, Green, and Blue LEDs (SEQ models only) — These
indicate the video signal that is selected by the Select button
b
( ) for skew adjustment using the Adjust control (
LED for the selected color flashes when the skew compensation
for that color's video signal has reached the minimum or
maximum limit.
d
Adjust skew control (SEQ models only) — This control delays
the selected red, green, or blue video signal by up to a maximum
of 62 nanoseconds (ns), in 2 ns incremental steps. Rotate the
control counterclockwise to reduce the delay or clockwise to
increase the delay.
2 3 4
RED
SELECT
GREEN
BLUE
ADJUST
DELAY
The SEQ receiver automatically saves the setting for the
video signal that is being deselected when this button is
pushed or when the selection times out after 10 seconds.
Press and hold the button in for approximately 3 seconds
to zero the skew delay for red, green, and blue. The Red,
Green, and Blue LEDS (
button.
See "Skew Delay Compensation"
MTP 1500RL 15HD RS Series • Installation
6
5
LEVEL PEAKING
MIN/MAX
RGB
6
5
LEVEL PEAKING
MIN/MAX
RGB
c
) all turn off. Release the
MTP 1500RL SERIES
MTP 1500RL SERIES
d
). The
for details.
10