Aap Mounting; Ul Rack Mounting Guidelines - Extron electronics VTT001 User Manual

Installation, cont'd
4.
5.

AAP mounting

The AAP versions of the VTT001 (VTT001 AAP) and VTR001
(VTR001 AAP) are mounted to the Extron AAP panel by
inserting the two AAP studs through the panel mounting holes
and attaching the nuts. See the following illustration.
Cable
Clamp
Figure 2-10 — Attaching a VTT001 AAP to an Extron
AAP frame

UL rack mounting guidelines

The following Underwriters Laboratories (UL) guidelines
pertain to the safe installation of the device in a rack.
1.
2.
VTT001 and VTR001 • Installation
2-14
Attach the video input and output devices to the front
faceplates of the transmitter and receiver, respectively.
Power on all devices.
#4-40 Nut w/ Captive
Washer
Elevated operating ambient temperature — If installed in
a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be
greater than room ambient temperature. Therefore,
install the unit in an environment compatible with the
maximum ambient temperature (Tma = +122 °F, +50 °C)
specified by Extron.
Reduced air flow — Install the equipment in a rack so that
the amount of air flow required for safe operation of the
equipment is not compromised.
AAP 102
Cable
0 2
P 1
A A
T
P U P
A A
IN
0 1
T 0
V T
VTT001 AAP