Table of Contents
Advertisement
8. Paper Specifications and Adding Paper
4.
Attach the tab fence, and then align the end fence gently against the paper you loaded
while pressing the release button of the end fence.
5.
Carefully push the paper tray fully in until it clicks.
6.
Specify the paper settings.
page 289 "Overview of Paper Settings"
• Replace the tab fence after use.
Attaching the small tab end fence to the two-tray wide LCT
When loading the following paper, attach the small tab end fence:
• B5 JIS
(width: 182 mm; length: 257 mm)–SRA4
Weight 9
• Carbonless paper of Paper Weight 2 or less
1.
Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2.
Take out the small tab end fence from the pocket on the right-hand side of the paper
source tray.
234
D0CPIC1393
(width: 225 mm; length: 320 mm) of Paper
D0CPIC1394
Advertisement
Table of Contents
