Table of Contents
Advertisement
8. Paper Specifications and Adding Paper
3.
Insert the paper print side up as far as it will go into the machine.
To load paper on the banner sheet guide tray, load it over the joint line of the bypass tray and the
banner sheet guide tray.
4.
Put your fingers on the dimples on the front and rear paper guides and align the paper
guides to the paper size.
If the guides are not flush against the paper, images might be skewed or paper misfeeds might
occur.
5.
While holding the paper guides with your hands, lock both of the paper guides again.
Make sure that the total of the gaps between the paper and the front and rear paper guides does
not exceed 0.75 mm (0.03 inches).
6.
Specify the paper settings.
page 289 "Overview of Paper Settings"
Loading Paper into the Multi Bypass Tray (Tray A)
• The maximum number of sheets you can load at the same time depends on paper type. Do not
stack paper over the limit mark. If you load paper over the limit mark, the printed images may
become slanted or a paper jam may occur. For details about the maximum number of sheets you
can load for each paper type, see the following:
• page 241 "Recommended Paper Sizes and Types"
• Check the paper edges are aligned at the left side.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, the paper may
misfeed, or if it weighs between 52.3–63.0 g/m
1.
Set the side fences to the paper size, and then square the paper and load it print side up.
Do not stack paper over the limit mark.
214
D0CPIC1358
2
(14.0–16.9 lb. Bond), it may wrinkle.
Advertisement
Table of Contents
