Polaris PVCR 3300 IQ Home Aqua Operation Manual page 84

8. Do not dip the appliance and the charger into water or other liquids.
9. Do not clean the appliance by means of petrol, alcohol, and chemical solvents.
10. Metal parts of the appliance shall be wiped with a clean dry tissue napkin.
11. Plastic parts of the appliance shall be wiped with a tissue napkin squeezed dry. There shall be no water
droplets.
12. The appliance shall be stored in a dry cool place.
Pre-operation preparation of the wet cleanup container
Attention! If during wet cleanup the robot is stopped (to add water), it can repeat cleaning a previously
cleaned area upon its operation resumption. Do not use the wet cleanup option on carpets.
Make always sure to preliminarily add fresh water into the container; empty the container completely
each time after vacuuming. Make always sure to detach this container before charging the battery.
Prior to adding water, have the container bottom fitted with the mop out of the delivery set, as per the
Figure. Fig. 11
Water addition.
Open the fill port lid, carefully add fresh water up to the upper mark. CLose the lid tightly.
DUST CONTAINER CLEANING
Fig. 16
Each time after vacuuming:
- Push the dust container latch, and pull downwards,
- Extract the container by pulling it on.
- Check for any foreign items stuck in the channels. If any, remove them.
- Open the container lid by pulling the latch downwards,
- Flip over the container and shake out any debris from it.
- To extract and replace HEPA-filter, release the latch on the dust container lid. Clean the HEPA-filter by
shaking it down or by means of special brush. At necessity, wash HEPA-filter by a thin jet of fresh water
of room temperature. No detergents shall be applied. Fig. 17
- Wash the dust container by fresh water. Fig. 18
- Prior to install the filters, dry them in the natural way.
No heating is allowed.
- Install the filtering elements,
- Close the container lid, and install in its place.
WET CLEANUP CONTAINER CLEANING.
After vacuuming, switch off the appliance, detach the container. Detach the mop from its holders.
Wash the mop by water with a detergent, then rinse in fresh water, dry in the natural way (without
heating). Fig. 19
Empty the container, and keep it dry.
CENTRAL BRUSH CLEANING
The electric brush is intended for collecting household dust from the floor and carpets by means of the
rotable bristle roller. It is intrinsically quite susceptible to being clogged with long hairs, wool, threads
etc. In case of clogging, immediately stop the vacuum cleaner operation, and take measures to clean the
bristle roller. The cleaning shall take place each time after vacuuming.
The roller is equipped with the its own electric drive which actuates simultaneously with the vacuum
cleaner motor.
To clean the roller:
Turn off the appliance by the I/O switch (set the switch to "O" position).
1.
Flip over the vacuum cleaner and position it so that its rear part faces you.
2.
84