Polaris PVCR 3300 IQ Home Aqua Operation Manual page 81

until the
second beep
VACUUM CLEANER FEATURES COVERED IN APPENDIX
(detailed description of features and peculiarities of the appliance operation is given in the following
chapter).
1. Start/ stop
2. Remote control of motion direction (joystick)
3. Operation mode selection:
a. Auto
b. Wall-along cleanup
c. Targeted vacuuming (spot vacuuming)
d. Wet cleanup
e. Return to the base
4. Cleanup scheduling per days of the week
6. Battery charge indication
7. Sound on/off
8. Water feed and suction rate adjustment
9. Room cleanup map
10. Displaying of errors during the appliance operation
Note: The set and names of the functions available in the application may change without notifying the
user if the version of the application and the firmware of the device change.
Attention! Install the container with water for wet cleaning by removing the vacuum cleaner from the
base for recharging. This is necessary for electrical safety purposes and for the application to recognize
that the wet cleaning container is installed.
Attention!
Application operation and robot control using the remote control are not synchronized.
We recommend sticking to one of the control options: via the app or the remote control.
VACUUM CLEANER OPERATION WITHOUT USING REMOTE CONTROL OPTION
Put the vacuum cleaner on the floor so that the control panel is upward. Fig. 12
1.
Set the switch to "I" position. This causes turning the button
message about readiness for operation.
The robot get into the sleep mode in 10 minutes unless no activities with the appliance has occurred.
2. To run the main program, push once button
the room. The acoustic message about starting the main cleanup mode follows.
3. The next push on button
and the vacuum cleaner gets into the "Pause" mode. The respective acoustic signal follows.
4. To return the robot to the base, push button
turning orange on the control unit. Then, the acoustic message about the necessity in charging follows.
5. To switch off the vacuum cleaner, push ON/OFF button on the control unit, then set the power
switch to "O" position.
CLEANUP PROGRAMS.
without holding it down. The robot starts vacuuming
on the appliance or button
on the control unit. This causes button
81
indicator green, and uttering the
on the control unit stops the vacuuming,